Back to overview

DT 287 PV MK II LTD, 250 ohms, with limiter, for phantom power

Contact

Peter Grooff
Product Management Broadcast
Professional Audio Products

Theresienstr. 8
D-74072 Heilbronn

Phone: +49 (0)7131 - 617-440
broadcast@beyerdynamic.com

DT 287 PV MK II LTD, 250 ohms, with limiter, for phantom power

Available at authorized resellers

Article Number: 498025

Single-ear headset with condenser microphone for on-air news and sports commentaries (with limiter).

Here you can find more information about the beyerdynamic limiter concept.

PLEASE NOTE >> The standard Limiter is set to 99 dB (max. 105 dB), different required values must be specified when ordering.

The headsets in this series dispose of a dynamic headphone transducer with a frequency response of 10 – 30,000 Hz and excellent isolation from ambient noise. The single cable is detachable, the ear cushions are replaceable. The pivoting gooseneck microphone- boom design, can be swivelled to work on the left or right side of the headset, or set to the upper position when not in use.

▲ NEW - Improvement of immunity against RFI (Radio Frequency Interference) caused by GSM, DECT, UMTS, Tetra etc.
▲ Good ambient noise attenuation
▲ High-quality condenser cardioid microphone for improved bass response and high gain-before-feedback
▲ Very high speech reproduction quality and excellent intelligibility
▲ NEW - Flexible, pivotable gooseneck for optimal positioning with elastical microphone suspension
▲ Lightweight, low profile design
▲ Single-sided, detachable cable
▲ NEW - Limiter
▲ Powerful neodymium headphone system for excellent reproduction accuracy
▲ Optimised frequency response according to IRT (Institute for Radiotechnology in Munich) regulations
▲ Balanced sound impression
▲ Closed headphone
▲ Circumaural ear pads, advanced ear cushion system
▲ Adjustable, soft padded headband
▲ Service-friendly construction due to exchangeablitity of all parts

All DT 287 versions are supplied without connecting cable. Please order the appropriate connecting cable separately (see accessories) .

technical data

Transmission type		Wired
Headphone design (operating principle)		Closed
Headphone impedanceAlso known as nominal impedance. The impedance is the AC resistance of the coils of loudspeakers and headphones in ohms. Since impedance depends on the frequency, it is always specified at a frequency of one kilohertz.		250 ohms
Headphone frequency responseThe frequency response specifies the highest and lowest frequencies reproduced by the acoustic transducer of the headphones.		10 - 30.000 Hz
Nominal sound pressure levelThe acoustical level, the headphone transducer produces to an artificial ear (a measurement device, which simulates a human ear) with an input power of 1 mW (dB/mW @ 1 kHz).		100 dB SPL
Polar patternThe polar pattern is the preferred pick-up direction of the microphone. According to the shape of the corresponding measurement plot, there are omni-directional, cardioid, super-cardioid or hyper-cardioid as well as figure-of-eight patterns. for microphone		Cardioid
Transducer typeThe transducer system is designed as a dynamic moving coil microphone, as a ribbon microphone or as a condenser microphone. for microphone		Condenser
ConstructionSound coupling to the ear. A differentiation is made between supraaural headphones, circumaural headphones and in-ear headphones.		Circumaural (around the ear)
Cable & plug		Detachable cable – various connectors available
Net weight without packaging		314 g